State Electricity Board Line Cutting Control System using PC

(3 customer reviews)

5,2287,723

Available Options:

SKU: EPK- 038 Category:

Description

Abstract:

State Electricity Board (SEB) Line Cutting Control System using PC is provides facility to control the State Electricity Board electric line cutting control by software on PC. By using this project, admin can control his/her Industrial, Domestic and Commercial electric line cutting by managing date or time entered in the software installed in PC. In our project when particular date and time meets then our software sends signal to micro controller for further process via MAX232 IC. Now micro – controller 8051 send the proper commands to the ULN 2003 IC which controls the relays. These relays control cutting the line connected to it, thus electric to that particular line (Industrial, Domestic and Commercial) with help of these relay. The admin has option to enter the separate date and time for each of three Industrial, Domestic and Commercial line

for electric line cutting. Then our system continuously checks date and time matching, if its meet then it start further process.

PC Interface:

Electric Line Cutting System

State Electricity Board Line Cutting Control System using PC

In our project we use a circuit connected to PC via RS232. There is small window based software to operate this project. Administrator only has to run this software and then after use the PC keyboard and mouse to operate this. The circuit has an 8051 micro- controller, which receives user commands from PC through RS232, sends commands to the ULN2003. The ULN2003 IC, Relay Driver IC, connected in between micro – controller and relays. Thus, each relay receives signal from this IC and be ON or OFF according to the commands. Along which these relay the electric line also control, each line has a particular relay as switch. Thus, our SEB Line Cutting Control System using PC control your electric line cutting system without any error. This system is economically cheap and easy to apply. There MAX 232 IC is used in the circuit for interfacing the PC to the microcontroller.

Additional information

Weight N/A
Project kit

Professional, Assembled, Combo, Learning

3 reviews for State Electricity Board Line Cutting Control System using PC

  1. Navaneethan

    I would like to buy this project, is it possible t interface with pc thorugh LabVIEW software, please clarify this doubt
    Thanks in advance.

    • IQBAL SINGH

      yes

  2. sergeibok

    vary use full Project. Good Work.

  3. glenn

    very good working, timely delivery

Add a review

Your email address will not be published. Required fields are marked *



Exclusive products

Special category of products

Provided by orange county fountain repair

News

Hi friends
First of all, we thank you because you may have used our website below.
We are happy to tell you that Techsodes Corporation has created the microcontroller open source code editor named as MikroStudio IDE first time in India. This software is a power full tool for code development of microcontrollers like 8031, 8032, 8051, 8052, Mcs51, AVR, PIC, STM8, Z80, EZ80, Z180, padauk, rabbit and gameBoy etc. It is absolutely free and is also better than other programmable software or IDE (Integrated Development Environment) because they can programmed only few microcontrollers. MikroStudio IDE has been support 3000+ microcontroller without installation other cores or plugin. MikroStudio IDE used sdcc, avr-gcc and gputils compilers. MikroStudio IDE has also provides you an open source hardware and software community where you can discuss your problems with us and that problem will be solved by the community.
Join community
Download MikroStudio IDE V2.2
Holler Box